This is pretty neat:
A standard 500GB Seagate 7200 SATA drive is plugged into one of the NexStar USB 3.0 docks to run a backup of the drive.
It is averaging about 90MB/Second for the job as of now. The job finished in a little over three minutes averaging 87.5MB/Second!
Compare that to the average 20MB/Second that same drive would have run on a USB 2.0 connection and we can see the time savings benefits right away for the refresh we did on this Data Mule system (previous blog post).
NOTE: We could not get the Vantec NexStar USB 3.0 dock (NST-D300S3) to work when it was plugged directly into the USB 3.0 port on the back of the Intel Desktop Board DQ67SW. We needed to plug a Vantec USB 3.0 Hub (UGT-MH430U3) into the motherboard’s port and then the NexStar into that before any drive would be picked up.
Philip Elder
MPECS Inc.
Microsoft Small Business Specialists
Co-Author: SBS 2008 Blueprint Book
*Our original iMac was stolen (previous blog post). We now have a new MacBook Pro courtesy of Vlad Mazek, owner of OWN.
2 comments:
Do you have recommended USB 3.00 card fro current generation Intel Server Motherboards?
Thanks
Justin
Jasper,
Anything I have seen so far has been "No-Name" stuff which would never find its way into a server.
If Adaptec, 3Ware, LSi, or other like storage vendor had one that would be the route we would go. Even if the card cost four times or more than the consumer card.
Thanks,
Philip
Post a Comment